Lignin is the richest source of renewable aromatics and has immense potential for replacing synthetic chemicals. The limited functionality of lignin is, however, challenging for its potential use, which motivates research for creating advanced functional lignin-derived materials. Here, we present an aqueous-based acid precipitation method for preparing functional lignin nanoparticles (LNPs) from carboxymethylated or carboxypentylated lignin. We observe that the longer grafted side chains of carboxypentylated lignin allow for the formation of larger LNPs. The functional nanoparticles have high tolerance against salt and aging time and well-controlled size distribution with Rh≤60 nm over a pH range of 5-11. We further investigate the layer-by-layer (LbL) assembly of the LNPs and poly (allylamine hydrochloride) (PAH) using a stagnation point adsorption reflectometry (SPAR) and Quartz crystal microbalance with dissipation (QCM-D). Results demonstrate that LNPs made of carboxypentylated lignin (i.e., PLNPs with the adsorbed mass of 3.02 mg/m2) form a more packed and thicker adlayer onto the PAH surface compared to those made of carboxymethylated lignin (i.e., CLNPs with the adsorbed mass of 2.51 mg/m2). Theoretical flux, J, and initial rate of adsorption, 〖(dГ/dt)〗_0, analyses confirm that 22% of PLNPs and 20% of CLNPs arriving at the PAH surface is adsorbed. The present study provides a feasible platform for engineering LNPs with a tunable size and adsorption behavior, which can be adapted in bionanomaterial production.
|Tidskrift||ACS Applied Materials & Interfaces|
|Status||Publicerad - 2021|