Cyclic Carbonation Calcination Studies of Limestone and Dolomite for CO2 Separation From Combustion Flue Gases

S Senthoorselvan, S Gleis, S Hartmut, Patrik Yrjas, Mikko Hupa

    Forskningsoutput: TidskriftsbidragArtikelVetenskapligPeer review

    18 Citeringar (Scopus)


    Naturally occurring limestone and dolomite samples, originating from different geographical locations, were tested as potential sorbents for carbonation/calcination based CO2 capture from combustion flue gases. Samples have been studied in a thermogravimetric analyzer under simulated flue gas conditions at three calcination temperatures, viz., 750 degrees C, 875 degrees C, and 930 degrees C for four carbonation calcination reaction (CCR) cycles. The dolomite sample exhibited the highest rate of carbonation than the tested limestones. At the third cycle, its CO2 capture capacity per kilogram of the sample was nearly equal to that of Gotland, the highest reacting limestone tested. At the fourth cycle it surpassed Gotland, despite the fact that the CaCO3 content of the Sibbo dolomite was only 2/3 of that of the Gotland. Decay coefficients were calculated by a curve fitting exercise and its value is lowest for the Sibbo dolomite. That means, most probably its capture capacity per kilogram of the sample would remain higher well beyond the fourth cycle. There was a strong correlation between the calcination temperature, the specific surface area of the calcined samples, and the degree of carbonation. It was observed that the higher the calcination temperature, the lower the sorbent reactivity. The Brunauer-Emmett-Teller measurements and scanning electron microscope images provided quantitative and qualitative evidences to prove this. For a given limestone/dolomite sample, sorbents CO2 capture capacity depended on the number of CCR cycles and the calcination temperature. In a CCR loop, if the sorbent is utilized only for a certain small number of cycles (<20), the CO2 capture capacity could be increased by lowering the calcination temperature. According to the equilibrium thermodynamics, the CO2 partial pressure ill the calciner should be lowered to lower the calcination temperature. This can be achieved by additional steam supply into the calciner Steam could then be condensed in an external condenser to single out the CO2 stream from the exit gas mixture of the calciner A calciner design based on this concept is illustrated.
    Sidor (från-till)011801/1–011801/8
    Antal sidor8
    TidskriftJournal of Engineering for Gas Turbines and Power
    StatusPublicerad - 2009
    MoE-publikationstypA1 Tidskriftsartikel-refererad


    • calcination
    • carbonation
    • CO2 separation
    • limestone and dolomite
    • Combustion
    • flue gases

    Citera det här