Lignin and other aromatic substances released from spruce wood during pressurized hot-water extraction, Part 1: Extraction, fractionation and physico-chemical characterization

Ivan Sumerskiy, Andrey Pranovich, Bjarne Holmbom, Stefan Willför

    Tutkimustuotos: LehtiartikkeliArtikkeliTieteellinenvertaisarvioitu

    14 Sitaatiot (Scopus)

    Abstrakti

    Ground spruce wood was extracted with pressurized hot water in an accelerated solvent extractor (ASE) at 170 degrees C during 20, 60, and 100 min. Released aromatic substances (from 2.2 to 2.5% on wood basis) were isolated on XAD-7 resin and fractionated into lignin, oligomeric aromatic substances (OAS), and compounds insoluble in methanol (IMC). The separated aromatic fractions, and the ground wood before and after extraction, were characterized by physico-chemical methods (GC, GC-MS, HPLC-SEC, TG, DSC). The major part of the aromatic substances was oligomeric aromatic substances (OAS). This fraction increased significantly with the extraction time, while the yield of dissolved lignin increased only slightly with extraction time. Isolated lignins had a lower molar mass and differed considerably from spruce milled wood lignin (MWL). The isolated lignins were more stable against oxidative thermodegradation than spruce MWL. The UV-extinction coefficients at 280 nm were lower for the isolated lignins than for MWL.
    AlkuperäiskieliEi tiedossa
    Sivut387–397
    Sivumäärä11
    JulkaisuJournal of Wood Chemistry and Technology
    Vuosikerta35
    Numero6
    DOI - pysyväislinkit
    TilaJulkaistu - 2015
    OKM-julkaisutyyppiA1 Julkaistu artikkeli, soviteltu

    Keywords

    • Hot-water extraction
    • lignin characterization
    • lignin isolation
    • spruce wood
    • XAD-7 resin

    Viittausmuodot