Experimental and modelling study of partial oxidation of ethanol in a micro-reactor using gold nanoparticles as the catalyst

Erfan Behravesh, Teuvo Kilpiö, V. Russo, Kari Eränen, Tapio Salmi

Research output: Contribution to journalArticleScientificpeer-review

2 Citations (Scopus)

Abstract

A microreactor was used to oxidize ethanol to valuable products under atmospheric pressure. Nano-sized gold on alumina was used as heterogeneous catalyst in the microreactor. A uniform and stable catalyst coating in the microchannels was achieved by suspension method. The catalyst was characterized by transmission electron microscopy, X-ray photoelectron spectroscopy, energy dispersive X-ray analysis, nitrogen-physisorption and X-ray diffraction.The reaction system was studied by changing the operation conditions, i.e. the residence time and temperature (100–250 °C). The product stream was analyzed by on-line gas chromatography. The identified products were acetaldehyde, ethyl acetate, diethyl ether and ethylene. The aim of the study was to find out the operation conditions that favored the generation of the desired product. A detailed modelling work was included. A kinetic model was developed for the reaction system. Dynamic mass balance-based generic modelling was applied to estimate the rate parameters. gPROMs ModelBuilder, a highly advanced process modelling tool was used. The obtained selectivity for acetaldehyde formation was around 90% already at low temperatures. The mathematical model described the ethanol conversion and acetaldehyde selectivity very well. The experimental equipment, the catalyst, and the modelling approach are applicable for other gas-phase oxidation studies.

Original languageUndefined/Unknown
Pages (from-to)421–428
JournalChemical Engineering Science
Volume176
DOIs
Publication statusPublished - 2018
MoE publication typeA1 Journal article-refereed

Keywords

  • Chemical Reactions Engineering

Cite this