Top layer coatability on barrier coatings

A1 Originalartikel i en vetenskaplig tidskrift (referentgranskad)


Interna författare/redaktörer


Publikationens författare: Roger Bollström, Mikko Tuominen, Anni Määttänen, Jouko Peltonen, Martti Toivakka
Förläggare: ELSEVIER SCIENCE SA
Publiceringsår: 2012
Tidskrift: Progress in Organic Coatings
Tidskriftsakronym: PROG ORG COAT
Volym: 73
Nummer: 1
Artikelns första sida, sidnummer: 26
Artikelns sista sida, sidnummer: 32
Antal sidor: 7
ISSN: 0300-9440
eISSN: 1873-331X


Abstrakt

In this study, the influence of different surface characteristics of dispersion-coated barrier layers on top layer coatability is examined. The barrier layer consisted of platy pigments, such as talc and kaolin, combined with different amounts and types of latexes. Coating of the top coat was carried out using the reverse gravure technique in which a dispersion consisting of mineral pigments and latex is applied under slight pressure onto the barrier-coated substrate. Wettability and coatability were measured as a function of surface energy and surface roughness of the barrier layer and the surface tension of the top coat dispersion. Plasma and corona surface treatments were used to increase the surface energy and wettability without affecting the surface topography. The most important aspect for predicting the coatability was the wettability, especially the water contact angle, because the top coat is an aqueous suspension. Decreasing the surface tension of the top coat dispersion also improved the coatability, whereas roughness had only a minor effect.


Nyckelord

Barrier properties, Coatability, Surface properties, Surface treatment, Wettability

Senast uppdaterad 2020-28-02 vid 04:59