Length scales of solid clusters in a two-dimensional circulating fluidized bed of Geldart B particles

A1 Originalartikel i en vetenskaplig tidskrift (referentgranskad)

Interna författare/redaktörer

Publikationens författare: Debanga Nandan Mondal, Sirpa Kallio, Henrik Saxén
Förläggare: ELSEVIER
Publiceringsår: 2015
Tidskrift: Powder Technology
Volym: 269
Artikelns första sida, sidnummer: 207
Artikelns sista sida, sidnummer: 218
eISSN: 1873-328X


The flow pattern in a circulating fluidized bed (CFB) is characterized by clusters of particles. The length-scale distribution of solid clusters was analyzed both horizontally and vertically from a number of experiments carried out with Geldart B particles in a two-dimensional circulating fluidized bed. Cluster dimensions were found to be dependent on solid loading, superficial gas velocity and location in the bed. Large length scales were found to be typical for the bottom region, above which more narrow dense clusters are common. The majority of clusters in the upper part of the riser have a width less than 20 mm, which means that in CFD simulations of circulating fluidized beds the mesh resolution should be finer than 5 mm to accurately reproduce the clusters. However, a significant fraction, of the order of 10–15% of the measured cluster widths, was below 2 mm. This is about ten times the particle diameter which is the mesh spacing recommended in the literature for CFD simulation of CFBs. The findings of the study on the width and height distributions of the clusters may also be used as a point of comparison with corresponding measures observed in simulated systems, by which a quantitative validation of CFD results could be made.


Circulating fluidized bed, Cluster dimensions, image analysis, Length scale

Senast uppdaterad 2019-12-12 vid 03:13