Soluble semiconducting poly(3-octylthiophene) as a solid-contact material in all-solid-state chloride sensors

A1 Journal article (refereed)


Internal Authors/Editors


Publication Details

List of Authors: Sjoberg-Eerola P, Nylund J, Bobacka J, Lewenstam A, Ivaska A
Publisher: ELSEVIER SCIENCE SA
Publication year: 2008
Journal: Sensors and Actuators B: Chemical
Journal acronym: SENSOR ACTUAT B-CHEM
Volume number: 134
Issue number: 2
Start page: 878
End page: 886
Number of pages: 9
ISSN: 0925-4005


Abstract

All-solid-state chloride sensors based on poly(3-octylthiophene) (POT) as ion-to-electron transducer were studied by electrochemical impedance spectroscopy (EIS) and potentiometric measurements. POT was deposited by solution casting on a glassy carbon (GC) substrate and then coated with a layer of plasticized PVC, containing tridodecylmethylammonium chloride (TDMACI) as the ion-exchanger. Highly reproducible and stable chloride sensors were fabricated with the concentration of TDMACI in the PVC membrane varying in the range of 5-15% (w/w). The presence of TDMACI also in the POT layer was found to significantly decrease the electrode impedance but did not influence the potentiometric response of the chloride sensors studied. Conditioning of the POT layer in AgNO3, prior to casting of the PVC membrane, slightly improved the potential stability of the electrode (due to the presence of silver in POT) but did not lower the detection limit. The response of the GC/POT/PVC-TDMACI electrode was comparable to that of GC/PEDOT/PVC-TDMACI electrode studied earlier. However, the GC/POT/PVC-TDMACI electrodes are easier to prepare, as the electropolymerization step of PEDOT solid-contact can be avoided. The absence of water (layers) between the solid-contact and the PVC-TDMACI membranes was verified by performing the so-called "water-layer test". (c) 2008 Elsevier B.V. All rights reserved.


Keywords

all-solid-state chemical sensor, chloride sensor

Last updated on 2020-24-02 at 05:05