Defluidization of the oxygen carrier ilmenite – Laboratory experiments with potassium salts

A1 Originalartikel i en vetenskaplig tidskrift (referentgranskad)


Interna författare/redaktörer


Publikationens författare: Maria Zevenhoven, Christoffer Sevonius, Patrik Salminen, Daniel Lindberg, Anders Brink, Patrik Yrjas, Leena Hupa
Förläggare: PERGAMON-ELSEVIER SCIENCE LTD
Publiceringsår: 2018
Tidskrift: Energy
Tidskriftsakronym: ENERGY
Volym: 148
Artikelns första sida, sidnummer: 930
Artikelns sista sida, sidnummer: 940
Antal sidor: 11
ISSN: 0360-5442
eISSN: 1873-6785


Abstrakt

Use of biomass in combustion and subsequent CO2 capture ideally lead to negative CO2 emissions. New techniques for biomass conversion are Chemical Looping Combustion of Biomass (Bio-CLC) and Oxygen Carrier Aided Combustion (OCAC). In both techniques, the ash-forming elements of biomass, mainly consisting of potassium, calcium, sulfur, phosphorus, and chlorine, may interact with the oxygen carrier bed material, causing agglomeration and defluidization, and thus inhibit the oxidation/reduction reactions. The detailed mechanisms behind this effect are not properly understood. Ilmenite, an iron titanium mineral, is used as an oxygen carrier in both CLC and OCAC.In this study, the interactions between ilmenite and potassium compounds, typical for biomass ashes, were studied. Mixtures of ilmenite with different potassium compounds were thermally treated in a crucible in an oxidizing environment at 850 and 950 degrees C. These conditions are relevant for OCAC and in the parts of CLC where oxidation of the oxygen carrier takes place. The interactions between potassium compounds, KCl, KH2PO4, K2CO3 and K2SO4 and the carrier material, were studied using DTA-TGA, XRD, and SEM-EDS. Thermodynamic equilibrium calculations were carried out to verify the reactions.Results from the crucible tests were used to explain the behavior of ilmenite in the presence of potassium salts in a lab-scale fluidized bed conversion. The bed agglomeration mechanisms depend on the potassium salt: KCl glued the particles together, whereas K2CO3 reacted with the bed particles. KH2PO4 reacted with the bed material and glued the particles together. K2SO4 remained non-reactive and did not influence the agglomeration of ilmenite bed particles.


Nyckelord

Ash interaction, Chemical looping combustion (CLC), Defluidization, Ilmenite, Oxygen carrier aided combustion (OCAC)

Senast uppdaterad 2019-23-11 vid 02:53