Numerical investigation of Kraft recovery furnace wall temperature

A1 Originalartikel i en vetenskaplig tidskrift (referentgranskad)


Interna författare/redaktörer


Publikationens författare: Li BZ, Engblom M, Lindberg D, Brink A, Hupa M, Koschack R, Mueller C
Förläggare: PULP & PAPER TECHNICAL ASSOC CANADA
Publiceringsår: 2012
Tidskrift: J-For: the Journal of Science and Technology for Forest Products and Processes
Tidskriftsakronym: J-FOR
Volym: 2
Nummer: 5
Artikelns första sida, sidnummer: 41
Artikelns sista sida, sidnummer: 48
Antal sidor: 8
ISSN: 1927-6311


Abstrakt

Deposits can affect the in-furnace wall surface temperature in a Kraft recovery furnace. In CFD (Computational Fluid Dynamics) models of the Kraft recovery furnace, the wall surface temperature is frequently used as the heat-transfer boundary condition. Therefore, the effect of deposits must be taken into account in CFD models. In this work, CFD simulations of a Kraft recovery furnace were performed. Three approaches were used to provide the wall surface temperature as the heat-transfer boundary condition for the CFD model: A) a char-bed burning model was applied to the wall, and the surface temperature was calculated; B) the "radical deformation temperature" T-70 was used as the surface temperature; C) a slagging wall model was used, and the surface temperature was calculated. These three approaches emphasize different aspects of Kraft recovery furnace deposits. In particular, implementation of the stand-alone slagging wall model as part of a furnace model has been accomplished in this research. The in-furnace wall surface temperature and the radiative heat fluxes to the wall from the CFD simulations have been analyzed and evaluated using measurements made in the Kraft recovery furnace.

Senast uppdaterad 2019-12-11 vid 05:10