Fabrication of nanoperforated ultrathin TiO2 films by inkjet printing

A1 Originalartikel i en vetenskaplig tidskrift (referentgranskad)


Interna författare/redaktörer


Publikationens författare: Qian Xu, Jan-Henrik Smått, Jouko Peltonen, Petri Ihalainen
Förläggare: CAMBRIDGE UNIV PRESS
Publiceringsår: 2015
Tidskrift: Journal of Materials Research
Volym: 30
Nummer: 14
Artikelns första sida, sidnummer: 2144
Artikelns sista sida, sidnummer: 2150
ISSN: 0884-2914


Abstrakt

Fabrication of nanoperforated TiO2 thin films (NP-TiO2) on various substrates utilizing evaporation-induced self-assembly has been widely reported during recent years. For many applications, such as solar cells and gas sensors, it would be beneficial if the active material could be deposited onto a desired area or in the form of a pattern or array. In this study, inkjet printing was successfully used to produce NP-TiO2 at both ambient temperature and 60 degrees C. Especially for intermediate drop spacings (40 and 50 mu m), millimeter-sized homogeneous NP-TiO2 patches were obtained with similar NP structure as those being processed by dip coating and drop casting. Compared to ambient temperature, inkjet printing at 60 degrees C provides a narrower height distribution of the NP structures of about 5 nm. Compared to dip coating and drop casting, inkjet printing enables the deposition of the ink onto target areas, thus enabling the fabrication of microscale arrays and other patterned structures.


Nyckelord

Inkjet printing, TiO2

Senast uppdaterad 2019-06-12 vid 04:49